Synopsis 
 
The All-on-4® concept is one of the breakthroughs in Implant Dentistry, allowing the rehabilitation of the majority of edentulous arches without the need of bone grafting. Created at MALO CLINIC, the All-on-4® concept is backed up by more than 20 years of clinical research with excellent long-term
results.

In recent years there has been a significant development in implant dentistry concerning the use of digital tools. These tools provide a potential significant gain in the predictability of the procedures and patient safety.

Designed for those that want to integrate a complete digital workflow in the rehabilitation of total edentulous patients. Learn how to reverse plan your surgery based on the prosthesis design, digitally plan bone reduction and implant placement, design, print and finish guides and use all these tools on surgery day.

This course offers the participants a comprehensive training that will allow them to gain proficiency
in the planning and execution of complex full arch rehabilitations of the maxilla/mandible through
the All-on-4® concept and using a digital workflow.

Including live surgery, 3D planning and hands-on in printed models, the course will take you through
the relevant aspects of the MALO CLINIC Protocol, from patient selection, to digital planning, and
execution of the treatment on the day of the surgery.
 
PRE-COURSE
It is mandatory for you to watch the online course for all the theoretical concepts.
Bring your questions to the clinical team!
 
DAY 1
Welcome Desk
 LIVE Surgery of a Digital planned case
Introduction:
      - History of the All-on-4® (From analogical to digital & the NobelGuide)
      - Presentation of the softwares to be used
      - Demonstration of a digital All-on-4® clinical case
Planning:
      - Digital Protocol + Worfklow (digital decision tree)
Practical demonstration of intraoral scanning
Digital planning software basic commands
Digital preparation of the digital case
 
DAY 2
Hands-on | Designing of digital guides
      - Each participant will bring their own laptop and will have access to material to allow designing            their own guides for an All-on-4® case.
Hands-on | “3D printing: materials, methods and workflow”

DAY 3 - Hands-on (morning)
Hands-on | “3D printing: materials, methods and workflow” (continuation)
      − Each participant will perform an All-on-4® surgery and prosthesis relining using the guides in            printed models.
Tour of the Clinic
Course wrap-up and farewel